Enabling The Use Of Administrator Policy; D14049.04 - TANDBERG VCS Administrator's Manual

Grey Headline (continued)
Administrator Policy
To enable Administrator Policy:
•
VCS Configuration > Call Policy .
You will be taken to the Call Policy page.
•
xConfiguration Policy
AdministratorPolicy Mode
Once you have enabled the use of
Administrator Policy, you must define
the policy to be used. This is done
either via the web interface or by uploading a
CPL script.
If Administrator Policy is on but a policy has
not been configured, then a default policy will
be applied that allows all calls, regardless of
source or destination.
Overview and
Introduction Getting Started
Status

D14049.04

JULY 2008

Enabling the use of Administrator Policy

System VCS Zones and
Configuration Configuration Neighbors
Call Bandwidth
Processing Control
115
TANDBERG VIDEO COMMUNICATIONS SERVER
Administrator Policy Mode
On: Administrator Policy is enabled. If a CPL
script has been uploaded, this policy will be
used. Otherwise, the policy configured via the
Administrator Policy section will be used.
Off: Administrator Policy is not in use.
Save
You must click here for any changes to the
Administrator Policy Mode
Firewall
Applications Maintenance
Traversal
ADMINISTRATOR GUIDE
to take effect.
Appendices