Table of Contents
Advertisement
Troubleshooting
Responding to an Error Lamp Flashes
If an error lamp flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated
on the Message Display when [Status/Job Cancel] is pressed or the error lamp flashes for 1.5 seconds, check
the following.
Symptom
Cannot send fax.
10-10
Checkpoints
Is the modular cord
connected correctly?
Is Permitted FAX No. or
Permitted ID No.
registered correctly?
Has a communication
error occurred?
Is the destination FAX
line busy?
Does the destination
FAX machine respond?
Is there an error other
than above?
Corrective Actions
Connect the modular
cord correctly.
Check Permitted FAX
No. and Permitted ID
No..
Check error codes in the
TX/RX Result Report
and Activity Report. If
the error code starts with
"U" or "E", perform the
corresponding
procedure.
Send again.
Send again.
Contact your Service
Representative.
Reference Page
—
FAX Operation Guide
Chapter 6 "Registering
Permit FAX No." and
"Registering Permit ID
No."
FAX Operation Guide
Appendix
"Error Code List"
—
—
—
OPERATION GUIDE
Advertisement
Table of Contents
