Tray Sequence Examples - Xerox DocuPrint N2125 System Administrator Manual

Configuring Automatic Tray Switching
Tray Sequence
Examples
Table 1.33 Tray Sequence examples
Condition
The Tray Sequence is set to 1-2.
• All trays are set to
Letter
• There is no paper in Tray 1.
• Letter paper is requested with the source set to
Auto.
The Tray Sequence is set to 1-2-3.
• A Tray 2 paper source is requested.
• All trays meet the size/type requirement.
The Tray Sequence is set to 2-3.
• Trays 1 and 2 contain letter paper.
• Tray 3 contains legal paper.
• Legal paper from Tray 2 is requested.
1-122 System Administrator Guide
The examples in Table 1.33 discuss conditions and actions
that take place when various Tray Sequence settings are
used.
paper.
Action(s) Taken
The printer searches for letter paper in the tray
sequence order (1-2). Since Tray 1 is empty, the
printer feeds paper from Tray 2 until it becomes
empty. When Tray 2 becomes empty, the printer
prompts you to load paper. Although Tray 3 also
contains letter paper, it is ignored because it is not
part of the tray sequence, and the requested paper
is configured in at least one of the trays included in
the sequence.
The printer feeds paper from Tray 2 because it
meets the size and type requested. When Tray 2
becomes empty, the printer feeds from Trays 1 and
3.
The printer feeds from Tray 3 because it is the only
tray that meets the size and type requested.
Table 1.33 Page 1 of 2