Xerox DocuPrint N2125 System Administrator Manual page 191

Table 5.1 Control Panel Messages (continued)
Message
Load MBF
Size and Type
Load Tray 1
Size and Type
Load Tray 2
Size and Type
Load Tray 3
Size and Type
Maintenance Kit
Replace
Manual Feed
Size and Type
MBF Jam-
Remove All Paper
Memory Failure
Power Off/On
Menu Locked
Explanation/Corrective Action
Load paper of the size and type shown into the multi bypass feeder.
Load paper of the size and type shown into Tray 1.
Load paper of the size and type shown into Tray 2.
Load paper of the size and type shown into Tray 3.
The fuser count has reached 200,000 sheets (at end of life). The printer
shuts down after the job. The printer will continue to print, but over time
print quality will deteriorate. Replace the maintenance kit and reset the
maintenance counter as per the instructions provided in the kit.
Load paper of the size and type shown into the multi bypass feeder.
A paper jam has occurred while feeding from the multi bypass feeder.
Remove all paper from the multi bypass feeder, then refer back to the
Control Panel for further messages.
Controller memory has failed. Printing cannot resume. Power off and
power on the printer. If the problem persists, contact your service provider.
Appears on the bottom line of the display when a selected menu is locked
by the network administrator using a PJL command. Users are prohibited
from making any changes to the configuration parameters in the menu.
Control Panel Messages
Table 5.1 Page 4 of 8
Chapter 5: Troubleshooting 5-7