Xerox DocuPrint N2125 System Administrator Manual page 190

Control Panel Messages
Table 5.1 Control Panel Messages (continued)
Message
Init Failed
Disk Locked
Initializing...
Flash Memory
Insert Tray 1
Insert Tray 2
Insert Tray 3
Install
Print Cartridge
IOT NVM Fail
Power Off/On
Laser Failure
Power Off/On
Load Env. Feeder
Size and Type
5-6 System Administrator Guide
Explanation/Corrective Action
The printer cannot put the disk in factory default condition because an
attempt has been made to initialize the disk after it has been locked via a
PJL or SNMP command.
The printer is initializing the flash memory.
The printer cannot feed from Tray 1 because the tray is open or removed.
Reinstall/insert the tray to resume printing.
The printer cannot feed from Tray 2 because the tray is open or removed.
Reinstall/insert the tray to resume printing.
The printer cannot feed from Tray 3 because the tray is open or removed.
Reinstall/insert the tray to resume printing.
The laser print cartridge is missing or is not installed correctly. Install the
laser print cartridge according to the directions for "Replacing the Laser
Print Cartridge" (page 4-3).
The NVM (Non Volatile Memory) has failed on the IOT (Image Output
Terminal) which is also called the print engine. Printing cannot resume.
Menu operations may have to be halted if this error occurs. Power off and
power on the printer. If the problem persists, contact your service provider.
The laser assembly has failed. Power off and power on the printer. If the
problem persists, contact your service provider.
Load paper of the size and type shown into the Envelope Feeder.
Table 5.1 Page 3 of 8