Paper Size/Type Mismatch - Xerox DocuPrint N2125 System Administrator Manual

Configuring Automatic Tray Switching
Paper Size/Type
Mismatch
1-124 System Administrator Guide
Paper size/type mismatch occurs when the requested size
is not available in the printer. This can be caused by
running out of paper in a tray that is configured for the
requested paper, or by requesting a paper that is not
configured in the printer. The printer goes off-line under
paper mismatch conditions. It automatically returns
on-line and continues printing after the paper mismatch
condition is resolved.
If a tray is configured for the requested paper, but the tray
is out of paper, the display prompts you to load the
requested paper (size and type) in the appropriate tray.
After the tray is loaded, printing continues.
If the request is for paper that is not configured in the
printer, you are prompted to load the requested paper in
the first tray of the Tray Sequence setting.
If you do not want to load paper in the first tray of the
Tray Sequence setting, two options are available:
• One of the trays may be loaded with the requested size
paper and reconfigured via the Tray Menu to match
the requested paper type. (See Table 1.10 on page 1-24
for instructions on using the Tray Menu.)
• Value Up or Value Down may be pressed to scroll
through all the trays, displaying the size and type
paper in each tray. If one of these alternate papers is
acceptable, pressing Enter will cause printing to
continue on the new paper. Trays are searched in the
order specified in the Tray Sequence setting.