Xerox DocuPrint N2125 System Administrator Manual page 184

Maintenance Kit Instructions
4-16 System Administrator Guide
6 Install the fuser screws and hand tighten.
Install the duplex module, if removed in Step 3, by
sliding the unit in until the green levers snap into
place.
7 Close the rear cover.
If you are installing the entire maintenance kit
(fuser, bias transfer roller and feed rollers), refer
to the installation instructions that came with
your kit to reset the maintenance counter. If you
have misplaced the maintenance kit instructions
package, contact Customer Support.
8 Reconnect the printer's power cord and power on the
printer.
Check the Control Panel display. Wait until
9
displayed. If an error message appears, refer to Table 5.1
on page 5-4 for instructions.
Ready is