Oce ColorWave 600 User Manual page 118

Set the default print job settings
[38]
Setting
'Media source'
'Print cut method'
[124]
'Custom print length'
'Add leading strip'
[125]
'Add trailing strip'
[126]
Overview of the default print job settings - Image
Editable for Key operator and Power user.
'Preferences' - 'Print job defaults' - 'Image'
118 Chapter 4 Configure the printing system
Description
The 'Media source' setting can be used to select the
default output material and format. The 'System' screen
of the printer operator panel will show you what rolls are
currently loaded.
You can select a specific roll number that the Océ
™
ColorWave 600 must use by default.
If you select 'Automatic next larger' or 'Automatic exact
fit' the Océ ColorWave
that matches the required output size of your print file.
Select 'Standard' to cut the print to a standard media
■
size (DIN, ANSI, ...)
Select 'Synchro' to cut the print at the end of the
■
image. The system cuts at the measured length of the
original times the scale factor.
Select 'Custom' (numeric) to cut the print on a
■
specified length. The print length is defined by value
of the setting 'Custom print length'.
Print length if the 'Print cut method' is set to 'Custom'.
When you enter a value, the Océ ColorWave
blank strip of the specified length at the beginning of the
output.
When you enter a value, the Océ ColorWave
blank strip of the specified length at the bottom of the
output.
™
600 will try to use a roll format
™
™
600 adds a
600 adds a