Table of Contents
Advertisement
Accessing the DSL Router
Changing Access Session Levels
Local Console Access
2-2
H
You can change the Administrator access level by entering:
admin enable
This command provides Administrator access level privileges. The DSL
router will respond with a prompt to enter the password for Administrator
access.
H
You can end the Administrator access level by entering:
admin disable
This command results in ending the Administrator access level session. No
password is needed.
Entering exit has the same results. Refer to
page 2-5 for further details on ending a session.
The Operator and Administrator have the same Login ID with different passwords
for their access level. To determine the level of access for a session, refer to
Determining the Current Access Level
The DSL router ships with the local console enabled. After login, the local console
can be disabled with the command console disable. After saving this
command and ending the session, there is no local access through the console
port. All access must be through a Telnet session.
NOTE:
Entering console disable results in NO local access to the DSL router.
To determine if the local console is enabled, log in and enter:
show console
The display returned for the show console command will be:
H
console enabled – Command line management at the local console is
available, or
H
console disabled – No command line management is available at the
local console.
For steps to set up the new user's login, refer to
on page 2-3.
March 2000
Exiting from the System
on page 2-4.
Setting Up the New User's Login
on
6371-A2-GB20-00
Advertisement
Table of Contents
