Configuring Bfd Echo Packet Mode For Static Routing - HP 4800G Series Configuration Manual

Master IP
# When the uplink of Switch A goes down, display the detailed information of VRRP group 1 on Switch
B.
<SwitchB> display vrrp verbose
IPv4 Standby Information:
Run Method
Total number of virtual routers: 1
Virtual IP Ping
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
# Display the track entry information of Switch A.
<SwitchA> display track 1
Track ID: 1
Status: Negative
Reference Object:
BFD Session:
Packet type: Echo
Interface : vlan-interface3
Remote IP : 1.1.1.2
Local IP : 1.1.1.1

Configuring BFD Echo Packet Mode for Static Routing

Network requirements
Configure a static route on Switch A to Switch C and enable BFD. When the link between Switch A and
Switch B fails, Switch A selects Switch D to reach Switch C.
Figure 1-11 Network diagram for BFD configuration on a static route
Configuration procedure
1) Configure BFD
: 192.168.0.102
: VIRTUAL-MAC
: Enable
: vlan-interface2
: 1
: UP
: 100
: YES
: NONE
: 192.168.0.10
: 0000-5e00-0101
: 192.168.0.102
Adver. Timer : 1
State : Master
Run Pri : 100
Delay Time : 0
1-33