HP 4800G Series Configuration Manual page 1617

[SwitchB–vlan-interface2] vrrp vrid 1 virtual-ip 192.168.0.10
[SwitchB–vlan-interface2] return
Use the display vrrp verbose command to display the configuration.
# Display the detailed information of VRRP group 1 on Switch A.
<SwitchA> display vrrp verbose
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Total number of virtual routers: 1
Interface : vlan-interface2
VRID : 1
Admin Status : UP
Config Pri : 110
Preempt Mode : YES
Auth Type : NONE
Track Object : 1
Virtual IP : 192.168.0.10
Virtual MAC : 0000-5e00-0101
Master IP : 192.168.0.101
# Display the detailed information of VRRP group 1 on Switch B.
<SwitchB> display vrrp verbose
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Total number of virtual routers: 1
Interface : vlan-interface2
VRID : 1
Admin Status : UP
Config Pri : 100
Preempt Mode : YES
Auth Type : NONE
Virtual IP : 192.168.0.10
Master IP : 192.168.0.101
The display above shows that, in VRRP group 1, Switch A is the master router and Switch B the backup
router.
# When the uplink of Switch A goes down, use the display vrrp command to display the detailed
information of VRRP group 1 on Switch A.
<SwitchA> display vrrp verbose
IPv4 Standby Information:
Run Method : VIRTUAL-MAC
Interface : vlan-interface2
VRID : 1
Admin Status : UP
Config Pri : 110
Preempt Mode : YES
Auth Type : NONE
Track Object : 1
Virtual IP : 192.168.0.10
Adver. Timer : 1
State : Master
Run Pri : 110
Delay Time : 0
Pri Reduced : 20
Adver. Timer : 1
State : Backup
Run Pri : 100
Delay Time : 0
Adver. Timer : 1
State : Backup
Run Pri : 90
Delay Time : 0
Pri Reduced : 20
1-32