Switching On And Off The Psu Switch On The Power Supply Unit; Figure 2.5 On Position (Marked "|") Of The Psu Switch On A Power Supply Unit - Fujitsu ETERNUS DX80 S2 User Manual
Disk storage system
Hide thumbs
Also See for ETERNUS DX80 S2:
- Cli user's manual (756 pages) ,
- User's manual & installation instructions (147 pages) ,
- User manual (144 pages)
Table of Contents
Advertisement
Chapter 2 Basic Operation
2.1 Powering On and Off
2.1.2
Switching On and Off the PSU Switch on the Power Supply Unit
This section explains how to switch the PSU switch of the power supply unit to ON and OFF in each enclosure.
■
To switch to ON
Turn the PSU switch of the power supply unit to the ON position (marked "|").
Make sure all of the PSU switches are in the ON position.
Figure 2.5 ON position (marked "|") of the PSU switch on a power supply unit
Drive enclosure
Controller enclosure
AC power is supplied to an enclosure.
•
For the controller enclosure, the POWER LED on the power supply unit blinks green.
•
For the drive enclosure, the POWER LED on the power supply unit and the LINE LED on the front emit green
lights and the fan revolves at high speed for 30 seconds.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Power supply unit (PSU#0)
35
Copyright 2013 FUJITSU LIMITED
Power supply unit (PSU#1)
P3AM-4842-12ENZ0
Advertisement
Table of Contents
