Fujitsu ETERNUS DX80 S2 User Manual page 84

Chapter 5 Maintaining Optional Products
5.2 Installing Drive Enclosures
6-3
Fasten the plug of the power cord with the release tie.
Wrap the release tie around the power cord and fasten the release tie from either side. Make sure
that the release tie is not loose.
6-4
Connect the power cord on the power socket side.
Connect the other end of the power cord plug to a power socket or an inlet on the power distribution
unit.
7
Turn the PSU switches of the power supply units (PSU#0 and PSU#1) in the drive enclosure
to the ON position (marked "|").
The power of the drive enclosure is turned on and the fan revolves at high speed for about 30 seconds.
8
Check that the LINE LED and the POWER LED on the drive enclosure are lit up.
9
In the [Add Drive Enclosure] screen, click the [Next>>] button.
The added drive enclosures are recognized and the installation completion screen appears.
10
Click the [Done] button.
The [Add Drive Enclosure] screen closes and the screen display returns to the [Drive Enclosure] screen.
11
In the [Storage] screen of [Component], check that the added drive enclosure is displayed.
12
To install more additional drive enclosures, repeat
13
Install the drives.
For details on drive installation, refer to
14
If a wrist strap is used, remove the wrist strap.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
LINE
FAULT
POWER
FAULT
84
Copyright 2013 FUJITSU LIMITED
Drive enclosure
Controller enclosure
Step 1 to Step
"5.1.4 Additional Drive Installation Procedure" (page
11.
67).
End of procedure
P3AM-4842-12ENZ0