Installable Long Wave Sfp+ Modules (16Gbit/S); Sfp+ Module Handling Instructions - Fujitsu ETERNUS DX80 S2 User Manual

Chapter 5 Maintaining Optional Products
5.4 Installing Long Wave SFP+ Modules (16Gbit/s)
5.4.2

Installable Long Wave SFP+ Modules (16Gbit/s)

For installable Long wave SFP+ modules (16Gbit/s), refer to "Product List".
5.4.3

SFP+ Module Handling Instructions

■ About condensation
CAUTION
■ About static electricity
CAUTION
■ About shock
CAUTION
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Do
• When moving an SFP+ module from a cold place, such as an un-conditioned
store house in winter, to a warmer places such as an air-conditioned room, the
severe temperature change may result in condensation forming.
To avoid this, allow the packed SFP+ modules sufficient time in the warmer
place (one hour for each 15°C of temperature difference) to adapt to the new
temperature.
Do
• When handling SFP+ modules, make sure to wear a wrist strap or touch a
metal part to discharge the human body's natural static electricity.
Failure to discharge static electricity may cause device failure.
• Leave the SFP+ module in its package until ready to install it.
Do Not
• Do not handle SFP+ modules roughly or subject them to physical shocks when
laying them down.
• Do not place any objects on top of SFP+ modules.
• Do not knock or drop SFP+ modules on hard objects.
88
Copyright 2013 FUJITSU LIMITED P3AM-4842-12ENZ0