Fujitsu ETERNUS DX80 S2 User Manual page 76

Chapter 5 Maintaining Optional Products
5.2 Installing Drive Enclosures
(5)
Push the M5 cage nuts into the 2nd holes of the front rack pillars above the base line of the drive
enclosure.
The M5 centering screw and M5 pan head screw positions for the slide rails and 2U rack rail are
determined relatively to the base line of the drive enclosure.
Tighten the screws referring to the following figure.
(M5 centering screw)
(M5 pan head screw)
■ For regions other than EMEA&I
(1)
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance between the front
and rear rack pillars. Leave the M4 screws slightly unscrewed, as the rack rail must be attached to
the rack before they can be completely tightened.
[Left]
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
[Left]
3rd position
2nd position
2U
Drive enclosure
(M5 cage nut)
1st position
Base line of
drive enclosure
Rack rail (for left side)
"L" is stamped on the inner
side of the rack rail
(for left side).
(Front rack pillars)
[Right]
Copyright 2013 FUJITSU LIMITED
[Right]
(M5 centering screw)
2nd position
(M5 cage nut)
1st position
(M5 pan head screw)
Rack rails
(Rear rack pillars)
Loosen the M4 screws, and
adjust the rack rails to the depth
of the rack.
Rack rail (for right side)
"R" is stamped on the inner
side of the rack rail
(for right side).
76
3rd position
P3AM-4842-12ENZ0