Fujitsu ETERNUS DX80 S2 User Manual page 177

Appendix B Audit Log List
Event code
020C0019
020C001A
020C001B
020C001C
020C001D
020C001E
020C001F
020C0020
020C0021
020C0022
020C0023
020C0024
020C0025
020C0026
020D0001
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Upper: Message
Lower: Detailed information
Recover Backup Restore Fail
Detail information is not displayed.
Recover Machine Down Recovery
Detail information is not displayed.
Reset All Controller Module
Detail information is not displayed.
Recover RAID Group
$a $b
[No= Mode= ]
Diagnose Disk
$a $b $c
[Disk= Count= Mode= ]
Diagnose RAID Group
$a $b
[No= Auto_Recovery= ]
Stop Diagnosis
$a $b
[Type= RAID_No= ]
Clear Diagnosis
$a $b
[Type= RAID_No= ]
Set LED
$a $b $c
[Target= Disk= LED= ]
Set Event Parameter
$a
[Warning_LED=
Comp_Redundant_Copy_LED= $b
Shutdown
$a
[Mode= ]
Set Differential Backup
$a
[Differential_Backup= ]
Set ODX Mode
$a
[Mode= ]
Set CLI Idle Timeout
[Timeout= $a ]
Update Customer Information
[Delete_Customer_Identity_Info=
Copyright 2013 FUJITSU LIMITED
The storage system is recovered from Backup Fail
status or Restore Fail status.
The Machine Down Recovery Fail status is reset.
All of the controllers are rebooted.
The RAID group is forcible recovered.
$a
: RAID group number
$b
: Recovery mode (Force, Disk)
The disk diagnosis is started.
$a
: Disk (DE-ID + Slot number (example:
0000, 0001, 0002))
$b : Count (1 - 65535)
$c
: Mode (Read Only, Write/Read/Compare)
The RAID group diagnosis is started.
$a : RAID group number
$b
: Recovery mode (Enable, Disable)
The diagnosis process is stopped.
$a : Type (Disk, RAID Group)
$b
: RAID group number
The diagnosis is complete.
$a
: Type (Disk, RAID Group)
$b
: RAID group number
The LED of the target component is turned on,
blinked, or turned off.
$a
: Target component (CE, Disk)
$b
: Drive (DE-ID + Slot number (example:
0000, 0001, 0002))
$c
: LED (ON, OFF)
The LED display (turning on or blinking) settings
when an event occurs are set.
$a
: Blink Fault LED at warning (Enable,
]
Disable)
$b
: Turn on Fault LED when redundant copy is
completed (Enable, Disable)
The storage system is off or rebooted.
$a
: Mode (Shutdown, Restart)
The differential backup function is enabled or
disabled.
$a
: Differential Backup (Enable, Disable)
The ODX function is enabled or disabled.
$a
: Mode (Enable, Disable)
The idle timeout limit when using ETERNUS CLI is
set or displayed.
$a
: Timeout limit [minute] (5 – 60)
The customer information is registered or
updated.
$a
]
$a
: Deletion of the customer information in
the storage system (Yes, No)
177
Description
P3AM-4842-12ENZ0