Fujitsu ETERNUS DX80 S2 User Manual page 156

Appendix B Audit Log List
No.
7 Format version
8 Time stamp
9 Processing time
10 Storage system
name
11 CM No.
12 Sequence number
13 Audit event code
14 Audit event result
15 Event result code
16 User name
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Item
Format version of the audit log is displayed.
"1" is output for all the messages.
A comma, and then a blank follow this item.
The local time when the processing result for the target event is defined is output.
A comma, and then a blank follow this item.
yyyy-mm-dd hh:mm:ss ±hh:mm
-
yyyy
The year is displayed with four digits.
-
mm
The month is displayed with two digits (01 – 12).
-
dd
The date is displayed with two digits (01 – 31). "T" and a blank follow this item.
-
hh:mm:ss
Local time. "hh" indicates the hour (00 – 23), "mm" indicates minutes (00 – 59),
and "ss" indicates seconds (00 – 59). A blank follows this item.
-
±hh:mm
Time differences between the local time and the GMT. The value for the time
zone specified in the date and time setting of ETERNUS Web GUI or ETERNUS CLI
is displayed. "hh" indicates the hour (00 – 23) and "mm" indicates minutes (00 –
59).
The time (seconds) it takes between starting the process for the target event and
obtaining the result is output.
"0" is output if this process takes less than 1 second. If this process takes 1 second or
longer, the value (seconds) is rounded off to the nearest whole number.
A comma, and then a blank follow this item.
A friendly name for the ETERNUS DX Disk storage system is output.
If a friendly name is not specified, no values are displayed.
A comma, and then a blank follow this item.
The CM number of the controller that detects the event is output.
A comma, and then a blank follow this item.
The message serial number is displayed for each controller.
A comma, and then a blank follow this item.
The event code is displayed as the 8-digit hexadecimal number.
A comma, and then a blank follow this item.
Refer to "Message List" (page 157)
The processing result for the event is output.
Detection: The processing result is detected.
Success: The process is succeeded.
Error: The process is failed.
A comma, and then a blank follow this item.
The event result factor code is output as the 8-digit hexadecimal number.
If the audit log result is "Success", no values are output.
When the event result is "Detection" or "Error", the error code of the interface which
performed the target event process is output.
For ETERNUS Web GUI: Error code for the ETERNUS Web GUI
ETERNUS CLI or Storage Foundation Software ETERNUS SF: Error code for the ETERNUS
CLI
A comma, and then a blank follow this item.
The user name of the account which performed the target event process is output. If the
user which performed the target event cannot be specified, no values are output.
A comma, and then a blank follow this item.
Copyright 2013 FUJITSU LIMITED
Description
for details.
156
P3AM-4842-12ENZ0