Long Wave Sfp+ Modules (16Gbit/S) Installation Procedure - Fujitsu ETERNUS DX80 S2 User Manual

Chapter 5 Maintaining Optional Products
5.4 Installing Long Wave SFP+ Modules (16Gbit/s)
5.4.4

Long Wave SFP+ Modules (16Gbit/s) Installation Procedure

This section describes how to replace a Short wave SFP+ module (16Gbit/s) in the host interface (FC 16Gbit/s)
with a Long wave SFP+ module (16Gbit/s).
CAUTION
Procedure
1
Check that all components of the ETERNUS DX Disk storage system are in normal status,
using the [Storage System Status] screen of ETERNUS Web GUI.
2
Check the port location of the Short wave SFP+ module (16Gbit/s) that is to be replaced by
using the Internal Parts information in the [Channel Adapter Detail] screen.
Note that a Short wave SFP+ module (16Gbit/s) is displayed as "16G SFP+(MMF)" in the "SFP Type" field.
3
Turn off the ETERNUS DX Disk storage system.
Refer to
system.
4
Wear a wrist strap or touch a metal part to discharge the human body's natural static
electricity.
5
Disconnect the FC cable that is connected to the FC port in the Short wave SFP+ module
(16Gbit/s) that is to be replaced.
Push the tab on the FC cable connector and pull out the cable.
Make sure to record the connecting port for the disconnected FC cable.
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
Do
• If SFP+ modules are installed in a way other as described here, damage and/or
device failure or electrical shock may occur.
"2.1.4 Powering Off" (page 38)
Copyright 2013 FUJITSU LIMITED
for details on how to turn off the ETERNUS DX Disk storage
89
P3AM-4842-12ENZ0