One Time N/8 Mm Feed; Set Vertical Tab Stops; Set Horizontal Tab Stops - Star Micronics TSP600 Series Programmer's Manual

One time n/8 mm feed

FUNCTION
CODE <ESC> "I"
1B
HEX
Performs a line feed n/8mm once only.
REMARKS
The value of n is 1 to 255.
Space setting for lines is not changed.

Set vertical tab stops

FUNCTION
CODE <ESC> "B"
1B
HEX
Cancels all current vertical tab stops and sets new vertical tab stops
REMARKS
at lines n1, n2, etc., where n1, n2, etc. are numbers between 1 and
255. A maximum of 16 vertical tab stops can be set.
The tab stops must be specified in ascending order; any violation
of ascending order terminates the tab stop list. Standard termina-
tion is by the <0> control code.
The vertical tab stops are set in terms of the current line spacing and
do not move if the line spacing is changed later.
Invalid when start position detect is valid.
<ESC> "B" <0> cancels all vertical tab.

Set horizontal tab stops

FUNCTION
CODE <ESC> "D"
1B
HEX
Cancels all current horizontal tab stops and sets new tab stops at
REMARKS
columns n1, n2, etc. at the current character pitch, where n1, n2,
etc. are numbers between 1 and 255. A maximum of 16 horizontal
tab stops can be set.
The tab stops must be specified in ascending order; any violation
of ascending order terminates the tab stop list. Standard termina-
tion is by the <0> control code.
The horizontal tab stops are set in terms of the current character
pitch and do not move if the character pitch is changed later.
<ESC> "D" <0> cancels all horizontal tab.
n
49 n
n1 n2
42 n1 n2
n1 n2
44 n1 n2
– 20 –
... <0>
... 00
... <0>
... 00