Star Micronics TSP600 Series Programmer's Manual page 41

2) Use N=3 for folloing settings
n1 :Character table
n2 :Character table
n3 :Print column
n4 :Line feed, CR code
Setting
n1
Character table
n2
n3 Print colum
n4 Line feed (mm)
CR code
Note: In order to enable the changed memory switch setting, turn
the printer OFF and ON again or send the printer reset
command (<ESC>"?") to the printer.
3) Use N=4 for folloing settings
a) TSP700
Setting
n1 Always "0"
n2 Always "0"
n3 Print colum
n4 Print area
n3 Print colum
0 EPSON
compatible
1 Max.
colum
n4 Print area
0 72 mm (576 dots)
1 52.5 mm (420 dots)
2 80mm
3 50.8 mm (406 dots)
0 1
See the table 1 (Nest page)
69 (TSP800) 55 (TSP800)
33/35/48/53 27/28/38/42
(TSP700) (TSP700)
33/48 27/38
(TSP600) (TSP600)
4 3
Invalid Invalid
0 1
See bolow (ESC/POS mode only)
Print area Left margin
72 mm (576dots) 32 dots
52.5 mm (420dots) 24 dots
80 mm (640dots) 40 dots
50.8 mm (406dots) 24 dots
72 mm (576dots) 0 dot
52.5 mm (420dots) 0 dot
80 mm (640dots) 0 dot
50.8 mm (406dots) 0 dot
(640 dots)
– 38 –
2
–
4
Valid
2
-
-
See bolow
Font-A
42 colums 56 colums
31 colums 41 colums
47 colums 63 colums
30 colums 40 colums
48 colums 64 colums
35 colums 46 colums
53 colums 71 colums
33 colums 45 colums
Roll paper width
80 mm
58 mm
82.5 mm
58 mm
3
–
3
Valid
3
Font-B