Star Micronics TSP600 Series Programmer's Manual page 12

CODE39: The value of k is optional, and the maximum
value also differs according to the modes.
The start/stop code ("
ITF: The value of k is optional, and the maximum
value also differs according to the modes.
If the data is number of an odd digits, 0 is
automatically added at the beginning of the data.
CODE 128: The value of k is optional, and the maximum
value also differs according to the modes and the
types of character number.
The check character is automatically added.
CODE93: The value of k is optional, and the maximum value
also differs according to the modes and the types
of character.
The check characters (C and K) are automatically
added.
NW-7: The value of k is optional, and the maximum
value also differs according to the modes and the
types of character number .
The start/stop code is also contained in the data (it
is not automatically added).
The bar code printing start position is at the upper end of the
current line.
If the bar code is positioned beyond the right margin, neither
the bar code nor the character below the bar code will be
printed.
Data of CODE 128 and CODE 93
When <LF> is used in a command, some kinds of control code
cannot be sent by the host PC. The control code should be sent
as the data as shown below:
When sending the following data, express as a set of two
characters.
") is automatically added.
*
– 9 –