Star Micronics TSP700 Series Replacing

80871410 IFTBD - HW03
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
This statement will be applied only for the printers marketed in U.S.A.
Statement of The Canadian Department of Communications Radio Interference Regulations
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the Radio Interference
Regulations of the Canadian Department of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe A
prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.
The above statement applies only to printers marketed in Canada.
EC Council Directive 89/336/EEC of 3 May 1989
This product, has been designed and manufactured in accordance with the International Standards EN 61000-6-3 / 2001 and EN 55024 / 1998,
following the provisions of the Electro Magnetic Compatibility Directive of the European Communities as of May 1989.
EC Council Directive 73/23/EEC and 93/68/EEC of 22 July 1993
This product, has been designed and manufactured in accordance with the International Standards EN 60950-1, following the provisions of the
Low Voltage Directive of the European Communities as of 2001.
EC Council Directive 99/5/EC of 9 March 1999
This product, has been designed and manufactured in accorda nce with the Essential Requirements of the Radio and Telecommunications
Terminal Equipment Directive 99/5/EC.
The above statement applies only to printers marketed in EU.
• This product contains a built-in wireless device and can only be used in the following countries.
Dieses Produkt enthält eine eingebaute drahtlose Einrichtung und kann nur in den folgenden Ländern verwendet
werden.
Ce produit renferme un dispositif sans fil incorporé et il ne peut être utilisé que dans les pays suivants.
Questo prodotto contiene un dispositivo senza fili incorporato e può essere utilizzato solo nei seguenti paesi.
USA, UK, France, Ireland, Belgium, Germany, Austria, Switzerland, Italy, Denmark, Norway, Sweden, Portugal,
Spain, Estonia, Finland, Greece, Iceland, Liechtenstein, Luxemburg, Netherlands, Canada, and Australia
• This product contains a built-in wireless device that meets the C-tick technical standards for Australia.
• This product contains Transmitter Module which conforms to the R&TTE Directive.
• This product contains Transmitter Module FCC ID: M4Y-0835C.
• This product contains Transmitter Module IC: 3195A-XI835C.
• Strictly observe the export control laws of the country for export when exporting this product.
The interface board is an option for the printer TSP700 series.
Use the following procedure to replace the interface board.
Interface Board
IFBD-HW03 ...... Wireless LAN

Replacing the interface board

Federal Communications Commission Radio Frequency Interference Statement
Manufacturer's Declaration of Conformity
N585
CE
A pp licable p rinter
TSP 700 Series
c Copyright 2004 Star Micronics Co., Ltd.