Star Micronics TSP600 Series Programmer's Manual page 59

Store dot graphic data into image memory
FUNCTION
CODE <ESC>
h1h2h3h4 ,
<LF>....nm1nm2....nmk"
1B
HEX
h1h2h3h4 2C w1w2w3 2Cn11n12n13n....n1k
<LF>....nm1nm2....nmk"
This command stores graphic data into image memory.
REMARKS
n
x1x2x3x4 : Print start position in the X direction. (0000 to 1040
y1y2y3y4 : Print start position in the Y direction. (0000 to 2000
h1h2h3h4 : Defines the length (Y direction) of the graphic area.
w1w2w3 : Defines the width (X direction) of the graphic area.
n11....nmk: n11 represents data in the 1st line. Each line ends with
Note:
"Q n x1x2x3x4
w1w2w3
51 n x1x2x3x4 2C y1y2y3y4 2C
: ";" : OR mode
":" : Overwrite mode
0.1 mm)
0.1 mm)
(0001 to 1600 dots)
(001 to 104 dots)
<LF>.
Data (X direction) appears in the same way as bit
image data. n21 represents data in the 2nd line.
a) This command can be used any number of times.
b) Size of graphic data is set in 1 mm units (byte units
(8 bits/bytes)) in the X direction and 0.125 mm units
(dot units) in the Y direction.
c) <ESC> "X" cancels data that was set using the
command.
d) If ";" or "," is missing, printer goes into an error
condition.
– 56 –
, y1y2y3y4
,n11n12n13n....n1k
<LF> <NUL>
0A 00
,