Command Specification - Star Micronics TSP600 Series Programmer's Manual

4-2. Command Specification

CODE
FUNCTION
OUTLINE
CODE
FUNCTION
OUTLINE
CODE
FUNCTION
OUTLINE
CODE
FUNCTION
OUTLINE
CODE
FUNCTION
OUTLINE
CODE
FUNCTION
OUTLINE
LF
(0A)
H
Print and line feed instruction
The LF code causes the data in the line buffer to be printed,
followed by a single line feed. When the line buffer is empty,
only the feed takes place.
CR
(0D)
H
Print and line feed instruction
Same function as of LF code.
However, when the DIP switch 1-3 is ON, the CR code
becomes invalid.
SO
(0E)
H
Expanded character instruction
This code causes the printer to print expanded characters
twice as wide as the regular ones. This remains in effect until
a DC4 code is received.
DC4
(14)
H
Release from expanded characters
The expanded character instruction is released by the DC4
code, and the succeeding data is printed as regular width
characters.
ESC-1
(1B) (2D) (01)
H H H
Underline mode selection
All data received after this code is underlined until a ESC-0
is received.
ESC-0
(1B) (2D) (00)
H H H
Release from underline mode
The underline mode selection is released by this code.
– 70 –
or (1B) (2D) (31)
H H
or (1B) (2D) (30)
H H
H
H