Star Micronics TSP600 Series Programmer's Manual page 39

Commands to Control Auto Cutter
Cut command to the auto cutter
FUNCTION
CODE <ESC> "d"
1B
HEX
n = "0" or <0> : TSP700/800
REMARKS
n = "1" or <1> : TSP600/700/800
n = "2" or <2> : TSP700/800
n = "3" or <3> : TSP600/700/800
Feed to the tear bar position (TSP600 only)
FUNCTION
<ESC> "d"
CODE
1B
HEX
Feeds the paper to the tear bar position.
REMARKS
n
64 n
Cuts the paper fully immediately.
Cuts the paper leaving one point uncut immedi-
ately.
Cuts the paper fully after feeding the paper to
the cutting position.
When print start position detect is ON, feeds the
paper to the next print start position first, feeds
the paper to the cutting position, then cuts the
paper fully.
Cuts the paper fully after feeding the paper to
the cutting position.
When print start position detect is ON, feeds the
paper to the next print start position first, feeds
the paper to the cutting position, then cuts the
paper leaving one point uncut.
"t"
64 74
– 36 –