Table of Contents
Advertisement
Using I/O Messaging
Chapter 5 provides information and examples that explain how to use a
ControlLogix controller to send I/O Messaging to control, configure, and
monitor a PowerFlex 40 drive.
Topic
About I/O Messaging
Understanding the I/O Image
Using Logic Command/Status
ATTENTION: Risk of injury or equipment damage exists. The
examples in this publication are intended solely for purposes of
!
example. There are many variables and requirements with any
application. Rockwell Automation, Inc. does not assume responsibility
or liability (to include intellectual property liability) for actual use of
the examples shown in this publication.
Important: At the time of publication, only ControlLogix controllers
About I/O Messaging
On EtherNet/IP, I/O messaging is used to transfer the data which
controls the PowerFlex drive and sets its Reference.
The EtherNet/IP adapter provides many options for configuring and
using I/O, including configuring the size of I/O by selecting the number
of attached drives (Single or Multi-Drive mode).
Chapter
3,
Configuring the
Scanner or
bridge on the network for these options. The
different options. This chapter discusses how to use I/O after you have
configured the adapter and scanner or bridge.
Page
5-1
5-2
5-2
can make an EtherNet/IP network I/O connection as
described in this chapter; PLC-5's and SLC's cannot.
However, these controllers can perform control using
explicit messaging to the CIP Register object and PCCC
N41 and N42 files.
Adapter, and
Bridge, discuss how to configure the adapter and scanner or
Topic
Using Reference/Feedback
Example Ladder Logic Program
Chapter
4,
Configuring the
Glossary
5
Chapter
Page
5-3
5-3
defines the
Hide quick links:
Advertisement
Table of Contents
