Setting Web Features Access - Allen-Bradley 22-COMM-E FRN 1.xxx User Manual

3-10 Configuring the Adapter

Setting Web Features Access

By accessing the IP address set for the adapter using a web browser, you
can view the adapter's web pages for information about the adapter, the
PowerFlex drive to which it is connected, and other DSI devices
connected to the drive such as HIMs, serial adapters or other daisy-
chained drives (when adapter is in Multi-Drive mode). Additionally, the
adapter can be configured to automatically send e-mail messages to
desired addresses when selected drive faults occur and/or are cleared,
and/or when the adapter takes a communication or idle fault action. For
more details on the adapter's web pages, refer to
Adapter's Web
By default, the adapter web pages are disabled.
To enable the adapter web pages
• Refer to
"Enable Web" (up) position.
Important: For a change to the switch setting to take effect, the
Bit 0 of Parameter 30 - [Web Features] is used to protect the
configured settings for e-mail notification. By default, settings are not
protected. To protect an e-mail configuration, set the value of E-mail Cfg
Bit 0 to "0" (Disabled). You can unprotect the configuration by changing
Bit 0 back to "1" (Enabled). E-mail notification will always remain
active regardless of whether or not its settings are protected — unless
e-mail notification was never configured. For more information about
configuring adapter e-mail notification or stopping e-mail messages,
refer to
Figure 3.11 Web Features Screen on Powerflex 4-Class HIM (22-HIM-*)
Access Control
Parameter:
VALUE
Bit 0 is the right-most bit. In
Changes to this parameter take effect immediately. A reset is not
required.
Pages.
Figure 2.1 and set the Web Pages Switch (SW2) to the
adapter must be reset (see
in this chapter).
Chapter 9, Configure E-mail Notification Web
#
x x x x x x 1
LIMITS
Resetting the Adapter
Bit Description
030
0 E-mail Cfg (Default = 1 = Enabled)
1 Proc Dsp Cfg (Default = 1 = Enabled)
1
2 - 7 Not Used
SEL
Figure 3.11 it is highlighted and equals "1."
Chapter 9, Viewing the
section
Page.