Quick Start - Allen-Bradley 22-COMM-E FRN 1.xxx User Manual

Quick Start

This section is provided to help experienced users quickly start using the
EtherNet/IP adapter. If you are unsure how to complete a step, refer to
the referenced chapter.
Step
1 Review the safety precautions for the adapter.
2 Verify that the PowerFlex drive is properly installed.
3 Install the adapter.
Verify that the PowerFlex drive is not powered. Then, connect
the adapter to the network using an Ethernet cable and to the
drive using the Internal Interface cable. Use the captive screw
to secure and ground the adapter to the drive.
4 Apply power to the adapter.
The adapter receives power from the drive. Apply power to
the drive. The status indicators should be green. If they flash
red, there is a problem. Refer to
5 Configure the adapter for your application.
Set the following parameters for the adapter as required by
your application:
• IP address, subnet mask, and gateway address
• Data rate
• I/O configuration
• Fault actions
6 Create a ladder logic program.
Use a programming tool such as RSLogix to create a ladder
logic program that enables you to:
• Control the adapter and connected drive using I/O.
• Monitor or configure the drive using Explicit Messages.
Chapter 8, Troubleshooting.
Getting Started
Refer to . . .
Throughout This
Manual
Drive User Manual
Chapter 2,
Installing the
Adapter
Chapter 2,
Installing the
Adapter
Chapter 3,
Configuring the
Adapter
Chapter 4,
Configuring the
Scanner or Bridge
Chapter 5,
Using I/O Messaging
Chapter 6,
Using Explicit
Messaging
1-5