Yamaha WR450F(W) Owner's Service Manual page 184

1 Clamp
2 Positive battery lead
3 Battery
4 Negative battery lead
5 Taillight coupler
6 CDI unit coupler (6-pin)
7 CDI unit coupler (3-pin)
8 CDI unit coupler (6-pin)
CABLE ROUTING DIAGRAM
È Fasten the wire harness to the upper engine
bracket (left side). Locate the clamp end facing
toward the upper side of the frame with the tie
end cut off on the inside of the frame.
É Fasten the wire harness to the upper engine
bracket (left side). Locate the clamp end facing
toward the upper side of the frame with the tie
end cut off on the inside of the frame. Clamp the
wire harness at the marking.
Ê Pass the starter motor lead through the hole in
the relay holder.
Ë Fit the cover securely.
Ì Connect the wire harness to the starter relay.
2 - 28
SPEC