Yamaha WR450F(W) Owner's Service Manual page 640

Wr series
Table of Contents

Advertisement

STEERING
9. Install:
• Plain washer 1
• Steering shaft nut 2
10. After tightening the nut, check the steering
for smooth movement. If not, adjust the
steering by loosening the ring nut little by
little.
11. Adjust:
• Front fork top end a
Front fork top end (standard) a:
Zero mm (Zero in)
12. Tighten:
• Pinch bolt (handle crown) 1
• Pinch bolt (under bracket) 2
CAUTION:
Tighten the under bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
13. Install:
• Multi-function meter bracket 1
• Multi-function meter 2
NOTE:
Pass the throttle cables 3, clutch cable 4 and
hot starter cable 5 between the multi-function
meter bracket and handle crown.
14. Install:
• Holder 1
• Clamp 2
NOTE:
• Install so that the marking a on the speed
sensor lead aligns with the holder edge.
• Fasten the speed sensor lead to the holder
with the clamp.
5 - 51
CHAS
145 Nm (14.5 m · kg, 105 ft · lb)
21 Nm (2.1 m · kg, 15 ft · lb)
21 Nm (2.1 m · kg, 15 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
13 Nm (1.3 m · kg, 9.4 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wr450f 2007Wr450fw 2007Wr450f

Table of Contents