Engine; Coolant Level Inspection; Coolant Replacement - Yamaha WR450F(V) Owner's Service Manual

ENGINE/COOLANT LEVEL INSPECTION/

COOLANT REPLACEMENT

a
b
EC350000

ENGINE

COOLANT LEVEL INSPECTION

WARNING
Do not remove the radiator cap 1, drain
bolt and hoses when the engine and radia-
tor are hot. Scalding hot fluid and steam
may be blown out under pressure, which
could cause serious injury.
When the engine has cooled, place a thick
towel over the radiator cap, slowly rotate
the cap counterclockwise to the detent.
This procedure allows any residual pres-
sure to escape. When the hissing sound
has stopped, press down on the cap while
turning counterclockwise and remove it.
CAUTION:
Hard water or salt water is harmful to the
engine parts. You may use distilled water, if
you can't get soft water.
1. Place the machine on a level place, and
hold it in an upright position.
2. Inspect:
• Coolant level
Coolant level should be between the
maximum a and minimum b marks.
Coolant level is below the "LOW" level
line → Add soft water (tap water) up to
the proper level.
3. Start the engine and let it warm up for sev-
eral minutes.
4. Turn off the engine and check the coolant
level again.
NOTE:
Before checking the coolant level, wait a few
minutes until the coolant settles.
COOLANT REPLACEMENT
WARNING
Do not remove the radiator cap when the
engine is hot.
3 - 5
INSP
ADJ