Yamaha WR450F(V) Owner's Service Manual page 482

1 a
b
c
AC MAGNETO AND STARTER CLUTCH
1
2
2. Install:
• Holder 1
• Bolt 2
NOTE:
• Pass the pick-up coil lead 3 and AC mag-
neto lead 4 under the holder as shown.
• Take care not to catch the AC magneto lead
between crankcase cover ribs.
• Apply the sealant to the grommet of the AC
magneto lead.
Quick gasket
ACC-QUICK-GS-KT
YAMAHA Bond No. 1215:
90890-85505
3. Install:
• Starter clutch drive gear 1
• Starter clutch 2
NOTE:
Apply the engine oil on the starter clutch drive
gear inner circumference.
4. Install:
• Woodruff key 1
• Rotor 2
NOTE:
• Clean the tapered portions of the crankshaft
and rotor.
• When installing the woodruff key, make sure
that its flat surface a is in parallel with the
crankshaft center line b.
• When installing the rotor, align the keyway c
of the rotor with the woodruff key.
4 - 83
ENG
7 Nm (0.7 m · kg, 5.1 ft · lb)
®
: