Throttle Lubrication; Hot Starter Lever Adjustment - Yamaha WR450F(V) Owner's Service Manual

THROTTLE LUBRICATION/

HOT STARTER LEVER ADJUSTMENT

NOTE:
Before adjusting the throttle cable free play,
the engine idle speed should be adjusted.
WARNING
After adjusting the throttle cable free
play, start the engine and turn the han-
dlebar to right and left and make sure
that the engine idling does not run faster.
THROTTLE LUBRICATION
1. Remove:
• Cover (throttle cable cap) 1
• Cover (grip cap) 2
• Throttle cable cap 3
2. Apply:
• Lithium soap base grease
On the throttle cable end a.
3. Install:
• Throttle cable cap
• Screw (throttle cable cap)
• Cover (grip cap)
• Cover (throttle cable cap)
HOT STARTER LEVER ADJUSTMENT
1. Check:
• Hot starter lever free play a
Out of specification → Adjust.
Hot starter lever free play a:
3 ~ 6 mm (0.12 ~ 0.24 in)
2. Adjust:
• Hot starter lever free play
Hot starter lever free play adjustment
steps:
• Loosen the locknut 1.
• Turn the adjuster 2 until free play a is
within the specified limits.
• Tighten the locknut.
NOTE:
After adjustment, check proper operation of
hot starter.
3 - 11
INSP
ADJ
4 Nm (0.4 m · kg, 2.9 ft · lb)