Document Feedback - Brocade Communications Systems Brocade 8/12c Command Reference Manual

Document conventions
3. Use the licenseIdShow command to display the switch WWN.
If you cannot use the licenseIdShow command because the switch is inoperable, you can get the
WWN from the same place as the serial number, except for the Brocade DCX. For the Brocade DCX,
access the numbers on the WWN cards by removing the Brocade logo plate at the top of the
non-port side of the chassis.

Document feedback

Quality is our first concern at Brocade, and we have made every effort to ensure the accuracy and
completeness of this document. However, if you find an error or an omission, or you think that a
topic needs further development, we want to hear from you. Forward your feedback to:
Provide the title and version number and as much detail as possible about your issue, including the
topic heading and page number and your suggestions for improvement.
xxxii
•
Brocade 7500E, 7800, and 8000—On the pull-out tab on the left side of the port side of
the switch
•
Brocade 5000—On the switch ID pull-out tab located on the bottom of the port side of the
switch
•
Brocade 7600—On the bottom of the chassis
•
Brocade 48000—Inside the chassis next to the power supply bays
•
Brocade DCX—On the bottom right on the port side of the chassis
•
DCX-4S—On the port side of the chassis, on the lower right side and directly above the
cable management comb
documentation@brocade.com
Fabric OS Command Reference
53-1001764-01