Brocade Communications Systems Brocade 8/12c Command Reference Manual page 24

•
•
•
•
Dynamic area mode on default switch
•
•
•
Encryption
•
•
•
•
•
•
•
•
•
•
•
Fabric Watch
The interactive Fabric Watch configuration interface (fwConfigure) has been replaced with a
command-driven set of new Fabric Watch commands. All Fabric Watch configuration and displays
can now be performed non-interactively. The legacy commands will be removed in a subsequent
release.
•
•
•
xxiv
fcipPathTest - Revised, updated examples.
turboRamtest - Revised, updated examples.
portLedTest - Updated examples.
portLoopBackTest - - Updated examples.
configure - New option to enable or disable Dynamic Area Mode.
portAddress - Port Address binding is now supported on the default switch as well after you
enable Dynamic Area Mode with the configure command.
wwnAddress - Dynamic Area Mode and WWN-Based persistent PID must be enabled on the
switch before you can assign an address with this command.
New command options to support replication for remote host access to data. Supported only
with RSA RKM key vault.
CryptoCfg --add - Enhanced to support replication (new -newLUN parameter).
CryptoCfg --decommission - New command group to support device decommissioning.
CryptoCfg --manual_rekey - Modified to support replication (-include_mirror with the -all
option).
CryptoCfg --rebalance - Support for combined disk and tape containers on a single
Encryption Engine including load balancing for optimized throughput.
CryptoCfg --refreshDEK - Rereads the mirror LUN metadata and updates the FPGA tables for
the LUN.
CryptoCfg --set -replication - Configures replication mode.
CryptoCfg --show -container - Enhanced display includes new parameters, "New LUN" and
"Replication LUN type".
CryptoCfg --show -groupcfg/-egstatus - Enhanced display "Replication Mode" status and
includes diagnostic output to detect incorrectly configured connectivity settings.
CryptoCfg --show -localEE - Enhanced display to show rebalance status.
CryptoCfg --sync -securitydb - Synchronizes security database across encryption group to
rectify master key propagation failure.
portThConfig - Support for VE_Ports and Copper ports added.
sysMonitor - Support for configuring Environment and Resources classes.
thConfig (see new commands) - Configures FW thresholds for the SFP, Fabric, Security, Filter,
and End-to-End Performance Monitor classes.
Fabric OS Command Reference
53-1001764-01