Configure - Brocade Communications Systems Brocade 8/12c Command Reference Manual

2

configure

configure
Changes switch configuration settings.
Synopsis configure
Description Use this command to change switch configuration settings.
Configuration data is grouped into chassis information and switch information. Each configuration
type is managed separately. For information on file format and specific parameters contained in
each section, refer to the configUpload help page.
The behavior of configure depends on the environment in which the command is executed:
•
•
To configure chassis-wide parameters, use the configureChassis command.
The following switch configuration parameters can be set with the configure command:
•
•
•
•
•
•
•
•
•
•
•
To access all parameters controlled by this command, you must disable the switch using the
switchDisable command. If executed on an enabled switch, only a subset of attributes are
configurable. Menu display may vary depending on the hardware platform.
Notes The maximum per port login limit is no longer configurable with this command. Use portcfgNPIVPort
--setloginlimit to configure this parameter on a per port basis.
The Telnet interface is no longer configurable with this command. Use the ipFilter command to
enable or disable the Telnet interface.
The SNMP attributes are no longer configurable with this command. Use snmpConfig --set
seclevel to configure SNMP attributes.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
132
In a Virtual Fabric environment, the configure command sets switch configuration parameters
for the current logical switch only. If a switch or chassis is configured with multiple logical
switches, you must configure each logical switch separately. Use setContext to change the
current logical switch context.
In a non-Virtual Fabric environment, the configure command sets switch configuration
parameters.
Switch fabric parameters
Virtual channel parameters
F_Port login parameters
Zoning operation parameters
Remote State Change Notifications (RSCN) transmission mode
Arbitrated Loop parameters
System Services settings
Portlog Events enable or disable settings
Secure Socket Layer (SSL) attributes
Remote Procedure Call Daemon (RPCD) attributes
Web Tools attributes
Fabric OS Command Reference
53-1001764-01