Brocade Communications Systems Brocade 8/12c Command Reference Manual page 87

--policy
Fabric OS Command Reference
53-1001764-01
and a higher level of security. When DH group is set to a specified value, only
that DH group is enabled. Specifying "*" enables all DH groups 0, 1, 2, 3, and
4, in that order. This means that in authentication negotiation, the NULL DH
group s given priority over all other groups.
-h sha1 | md5 | all
Sets the hash type. Valid values are "sha1", "md5" or "all", which sets both
hash types. Use this option to disable md5 authentication access by setting
the hash type to sha1 only. Disabling md5 access is required when
configuring the system for FIPS. Refer to the Fabric OS Administrator's Guide
for details on FIPS configuration.
Sets the switch authentication policy or device authentication policy. The
following options are supported:
-sw on|off|active|passive
Sets the switch authentication policy. Specify one of the following modes.
Operands are exclusive.
on Sets the switch authentication policy to ON mode. Strict authentication is
enforced on all E_Ports. The interswitch link (ISL) goes down (port disable), if
the connecting switch does not support the authentication or the
authentication policy is switched off.
off Turns the authentication policy off, and the switch rejects any authentication
requests.
active Sets the authentication policy to active mode. During switch initialization,
authentication is initiated on all E_Ports, but the port is not disabled if the
connecting switch does not support authentication or the authentication
policy is turned off.
passive (default)
Sets the authentication policy to passive mode. The switch does not initiate
authentication but participates in authentication if the connecting switch
initiates authentication.
-dev off|passive|on
Sets the device authentication policy. Two modes are supported. Device
authentication policy is off by default.
off Turns off the device authentication policy. Authentication is not required. The
switch ignores any authentication requests and continues with the FC
probing without authentication.
passive Sets the authentication policy to passive mode. Authentication is optional. If
the attached device is capable of doing the authentication then the switch
participates in authentication; otherwise it forms an F_Port without
authentication. In this mode the device accepts authentication on all F_Ports.
on Sets the authentication policy to "on" mode. Authentication is mandatory. If
the attached device is not capable of doing authentication, the corresponding
port is disabled.
2
authUtil
55