Switchenable - Brocade Communications Systems Brocade 8/12c Command Reference Manual

switchEnable

Enables all user ports on a switch.
Synopsis switchenable
Description Use this command to enable all user ports on a switch. All Fibre Channel ports that passed the
power-on self test (POST) are enabled. They can come online if connected to a device, or remain
offline if disconnected. Use switchEnable to re-enable the switch after making configuration
changes or running offline diagnostics.
If the switch is connected to a fabric, it rejoins the fabric. If the switch remains the principal switch,
it assigns itself a domain ID. If another switch assumes the principal role, then the re-enabled
switch becomes a subordinate switch and accepts a domain ID from the principal.
As each port is enabled, the front panel LED changes to green for online ports, or to yellow for
uninitialized ports. Disconnected ports remain unlit.
When this command is executed on a logical switch, only the ports allocated to the logical switch
are enabled. To enable the entire chassis, use the chassisEnable command.
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands none
Examples To enable a switch:
See Also bladeEnable, bladeDisable, chassisDisable, chassisEnable, CfgPersistentDisable,
switchCfgPersistentEnable, switchDisable, switchShow
Fabric OS Command Reference
53-1001764-01
switch:admin> switchenable
2
switchEnable
927