Portledtest - Brocade Communications Systems Brocade 8/12c Command Reference Manual

2

portLedTest

portLedTest
Cycles user port LEDs.
Synopsis portledtest [-npass count][-ports itemlist][-action value]
ceeportledtest [-npass count][-ports itemlist][-action value]
Description Use this command to exercise the user port LEDs in the current switch. For each port, the
command cycles through the ON and OFF state by setting the ATTN LEDs to green for the ON
condition and unlighted for the OFF condition. The SPEED LEDs are initially set to black before the
test starts. The SPEED LEDs turn green while the test is running.
portLedTest and ceePortLedTest are platform-specific versions of the same test. Use
ceePortLedTest on FCoE platforms only. Use fcipLedTest for GbE port testing on the Brocade 7800
and FX8-24.On all other platforms, use portLedTest.
You must disable the current switch (using the switchDisable command) before running this
command. After the command completes, the ATTN LEDs flash amber, indicating that the
command has finished and exited. Enable the current switch (using the switchEnable command) to
set the ATTN LEDs back to black.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Operands This command has the following operands:
-npass count
-ports itemlist
-action action
Examples To test port LEDs:
To test port LEDs on a Brocade 8000 using default values:
See Also fcipLedTest, itemList, switchDisable, switchEnable
710
Specify the number of times to perform this test. The default value is 10.
Specify a list of user ports on which to run the test. If omitted, all the active
ports in the switch are assumed. For more information, refer to the itemList
command.
Specifies the LED color. Valid values are:
0 Cycle all Port LEDs.
1 Turn Port status LED off.
2 Turn Port status LED amber.
3 Turn Port status LED green.
16 Turn Port speed LED green.
17 Turn Port speed LED amber.
switch:admin> portledtest -ports 1/1-1/5
PASSED.
switch:admin> ceeportledtest
PASSED.
Fabric OS Command Reference
53-1001764-01