Bladecfggemode - Brocade Communications Systems Brocade 8/12c Command Reference Manual

bladeCfgGeMode

Configures a GbE port or a 10GbE port on the Brocade FX8-24 blade.
Synopsis bladecfggemode --set mode -slot slot
bladecfggemode --show -slot slot | -all
bladecfggemode --help
Description Use this command to configure the GbE port mode on the Brocade FX8-24 extension blade or to
display the configuration. The mode configuration controls which ports are enabled.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
This command is supported only on the Brocade FX8-24 blade in a DCX or DCX-S4 chassis.
Operands This command has the following operands:
--set mode
--show
--help
Examples To configure the Brocade FX8-24 blade in slot 4 in 1G mode:
To display the GbE port mode for the Brocade FX8-24 blade in slot 4:
To display the GbE port mode for all configured slots:
Fabric OS Command Reference
53-1001764-01
Sets the GbE port mode for a specified slot. Valid modes are one of the
following:
1g Enables the GbE ports ge0-ge9 (xge0 and xge1 are disabled).
10g Enables the GbE ports xge0 and xge1 (ge0-ge9 ports are disabled).
dual Enables the GbE ports ge0-ge9 and xge0 (xge1 is disabled).
-slot slot Specifies the slot number for the FX8-24 blade. This operand is required
when setting the GbE port mode.
Displays the GbE port mode for the specified slots.
-slot slot Displays the GbE port mode for a single slot.
-all Displays the GbE port mode for all configured slots.
Displays the command usage.
switch:admin> bladecfggemode --set 1g –slot 4
switch:admin>
switch:admin> bladecfggemode --show –slot 4
bladeCfgGeMode: Blade in slot
10GigE mode: only xge0 and xge1 are enabled (ge0-9 ports are disabled)
switch:admin>
switch:admin> bladecfggemode --show –all
4 is configured in 10GigE Mode
2
bladeCfgGeMode
61