Portdisable - Brocade Communications Systems Brocade 8/12c Command Reference Manual

2

portDisable

portDisable
Disables a port or a range of ports.
Synopsis portdisable [slot/]port1[-port2] [...]
portdisable -i [index1[-index2] [...] [-f]]
portdisable -slot [slot1[-slot2] [...]
portdisable -h
Description Use this command to disable a port or a range of ports. If the port is connected to another switch
when disabled, the fabric may reconfigure. Devices connected to this port can no longer
communicate with the fabric.
You can identify a single port to be disabled by its port number or by its port index number. Port
ranges are supported with index numbers or by specifying a slot or a slot range. Use switchShow for
a listing of valid ports, slots, and port index numbers.
Specifying multiple ports with the index (-i) or slot (-s) option is supported only if PortSwap is
disabled. They are not supported on GbE ports and configured F_Port trunks. Use the -i option
without a port index argument to display the portSwap status, or alternately use portSwapShow.
The front panel LED of a disabled port flashes yellow with a two-second cycle. If the port was online
before being disabled, a state transition will be indicated in one of the following ways: RSCN, SNMP
trap, or Web pop-up window.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
This command is not supported on FCoE ports. To disable an FCoE port, use fcoe --disable.
Operands This command has the following operands:
slot
port1[-port2]
-i index1[-index2]
-slot [slot1[-slot2]
-h
700
On bladed systems only, specifies the slot number of the ports to be disabled,
followed by a slash (/).
Disables a single port or a range of ports identified by port numbers. The port
range cannot span slots, but you can specify multiple port ranges pairs
separated by a space, for example 3/1-4 4/7-9.
Disables a port or a range of ports identified by port index numbers. You may
specify multiple index ranges separated by a space, for example, -i 33-38
40-60.
-f Ignores nonexisting ports. This operand is valid only with the -i option.
Disables all ports on a slot or on a range of slots, for example, -s 3-5. You may
specify multiple slot ranges separated by a space, for example, -s 3-5 8-10.
Displays the command usage.
Fabric OS Command Reference
53-1001764-01