HP ProCurve 6120G/XG Configuration Manual page 442

File Transfers
Downloading Switch Software
7. After the primary flash memory has been updated with the new software,
N o t e
8. After you reboot the switch, confirm that the software downloaded cor­
Troubleshooting TFTP Download Failures. When using the menu inter­
face, if a TFTP download fails, the Download OS (Operating System, or
software) screen indicates the failure.
===========================-TELNET - MANAGER MODE -============================
Figure A-3. Example of Message for Download Failure
A-6
A "progress" bar indicates the progress of the download. When the entire
software file has been received, all activity on the switch halts and you
will see Validating and writing system software to FLASH...
you must reboot the switch to implement the newly downloaded software.
Return to the Main Menu and press
see this prompt:
Continue reboot of system?
Press the space bar once to change No to Yes, then press
the reboot.
When you use the menu interface to download a switch software, the new
image is always stored in primary flash. Also, using the Reboot Switch
command in the Main Menu always reboots the switch from primary flash.
Rebooting the switch from the CLI gives you more options. Refer to
"Rebooting the Switch" on page 6-19.
rectly:
a. From the Main Menu, select 1. Status and Counters, and from the Status
and Counters menu, select 1. General System Information
b. Check the Firmware revision line.
Current Software revision : Z.14.04
Method [TFTP] : TFTP
TFTP Server : 10.29.227.105
Remote File Name : os
Received 0 bytes of OS download.
+--------------------------------------------------------------------+
|
+--------------------------------------------------------------------+
Connection to 10.29.227.105 failed
(for Reboot Switch). You will then
[6]
: No
Download OS
Press any key to continue
[Enter] to begin
|