HP ProCurve 6120G/XG Configuration Manual page 434

Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Command
show cdp
show cdp neighbors [< port-list > detail]
[detail < port-list >]
[no] cdp run
[no] cdp enable < port-list >
N o t e
For details on how to use an SNMP utility to retrieve information from the
switch's CDP Neighbors table maintained in the switch's MIB (Management
Information Base), refer to the documentation provided with the particular
SNMP utility.
Viewing the Switch's Current CDP Configuration. CDP is shown as
enabled/disabled both globally on the switch and on a per-port basis.
Syntax: show cdp
The following example shows the default CDP configuration.
Figure 13-32. Example of Show CDP with the Default CDP Configuration
13-86
Lists the switch's global and per-port CDP configuration.
ProCurve# show cdp
Global CDP information
Enable CDP [Yes] : Yes (Receive Only)
Port CDP
---- --------
D1 enabled
D2 enabled
D3 enabled
D4 enabled
. .
. .
. .
Page
13-86
13-87
13-87
13-88