HP ProCurve 6120G/XG Configuration Manual page 386

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
Syntax: show sflow <receiver instance> sampling-polling <port-list/range>
The show sflow agent command displays read-only switch agent information.
The version information shows the sFlow version, MIB support and software
versions; the agent address is typically the ip address of the first vlan config­
ured on the switch
.
Figure 13-13. Example of Viewing sFlow Agent Information
The show sflow <instance> destination command includes information about
the management-station's destination address, receiver port, and owner.
ProCurve# show sflow 2 destination
Destination Instance
sflow
Datagrams Sent
Destination Address
Receiver Port
Owner
Timeout (seconds)
Max Datagram Size
Datagram Version Support
Figure 13-14. Example of Viewing sFlow Destination Information
Note the following details:
■
■
■
13-38
Displays status information about sFlow sampling and polling.
ProCurve# show sflow agent
Version
Agent Address
2
Enabled
221
10.0.10.41
6343
Administrator, CLI-owned, Instance 2
99995530
1400
5
Destination Address remains blank unless it has been configured.
Datagrams Sent shows the number of datagrams sent by the switch
agent to the management station since the switch agent was last
enabled.
Timeout displays the number of seconds remaining before the switch
agent will automatically disable sFlow (this is set by the management
station and decrements with time).
1.3;HP;W.14.XX
10.0.10.228