HP ProCurve 6120G/XG Configuration Manual page 255

ProCurve(config)# show interfaces brief
Status and Counters - Port Status
Port Type
----- --------- + --------- ------- ------ ----------
B1 100/1000T | No
B2 100/1000T | No
B3 100/1000T | No
B4 100/1000T | No
B5 100/1000T | No
B6 100/1000T | No
Figure 10-3. Example of Show Interfaces Brief Command Listing
Use the show interfaces config command to view the port settings, as shown
below.
Figure 10-4. Example of a Show Interfaces Config Command Listing
The display option can be used to initiate the dynamic update of the show
interfaces command with the output being the same as the show interfaces
command. When using the display option in the CLI, the information stays on
the screen and is updated every 3 seconds, as occurs with the display using
the menu feature. The update is terminated with Cntl-C.
You can use the arrow keys to scroll through the screen when the output does
not fit in one screen.
| Intrusion
| Alert Enabled Status Mode
Yes
Yes
Yes
Yes
Yes
Yes
ProCurve(config)# show interfaces config
Port Settings
Port Type | Enabled Mode
----- --------- + ------- ------------ --------- ----
B1 100/1000T | Yes
B2 100/1000T | Yes
B3 100/1000T | Yes
B4 100/1000T | Yes
B5 100/1000T | Yes
B6 100/1000T | Yes
Viewing Port Status and Configuring Port Parameters
MDI
Mode
----- ----- ------
Down Auto-10-100 Auto
Down 1000FDx Auto
Down 1000FDx Auto
Down 1000FDx Auto
Down 1000FDx Auto
Down 1000FDx Auto
Auto-10-100
Auto
Auto
Auto
Auto
Auto
Port Status and Configuration
Flow Bcast
Ctrl Limit
off 0
off 0
off 0
off 0
off 0
off 0
Flow Ctrl MDI
Disable Auto
Disable Auto
Disable Auto
Disable Auto
Disable Auto
Disable Auto
10-9