Post Error Codes And Messages - Gateway ALR 9200 Maintaining And Troubleshooting

Table 34: Port-80h Codes and Beep Codes (Continued)
Port-80 Beep
Codes Codes
BF
C0
D0
D4
D6
D8
DA
DC

POST Error Codes and Messages

The following error codes and messages are representative of various
conditions BIOS identifies. The exact strings and error numbers may be
different from those listed in Table 35.
Code Message
0162 BIOS unable to apply BIOS update to processor 1
0163 BIOS unable to apply BIOS update to processor 2
0164 BIOS does not support current stepping for processor 1
0165 BIOS does not support current stepping for processor 2
0200 Failure Fixed Disk
0210 Stuck Key
0211 Keyboard error
0212 Keyboard Controller Failed
0213 Keyboard locked - Unlock key switch
0220 Monitor type does not match CMOS - Run SETUP
0230 System RAM Failed at offset
0231 Shadow RAM Failed at offset
0232 Extended RAM Failed at offset
0250 System battery is dead - Replace and run SETUP
0251 System CMOS checksum bad - Default configuration used
0260 System timer error
0270 Real-time clock error
0297 ECC Memory error in base (extended) memory test in Bank xx
02B2 Incorrect Drive A type - run SETUP
02B3 Incorrect Drive B type - run SETUP
02D0 System cache error - Cache disabled
02F5 DMA Test Failed
Error Descriptions
Check virus and backup reminders
Try to boot with INT 19
Interrupt handler error
Pending interrupt error
Initialize option ROM error
Shutdown error
Extended Block Move
Shutdown 10 error
Table 35: POST Error Codes
Error and Informational Messages 173