Boot Menu - Gateway ALR 9200 Maintaining And Troubleshooting

Table 21: Console Redirection Submenu (Continued)
Field Options
Baud Rate 9600
19.2k
38.4k
115.2k
Flow Control No flow control
CTS/RTS
XON/XOFF
CTS/RTS + CD

Boot Menu

The boot menu contains seven fields that allow you to control the boot
process. Three of these fields open submenus. Table 22 lists the fields and
the options for each.
Field Options
Floppy Check Disabled
Enabled
Multi-boot Support Disabled
Enabled
Boot Device Priority N/A
Hard Drive N/A
Removable Devices N/A
Maximum Number of 1
I2O Drives 4
Message Timeout 1, 2, 8, 10, 50,
Multiplier 100, 1000
Description
When console redirection is enabled, this field
selects the baud rate.
When the Emergency Management Port (EMP)
shares the COM port as console redirection, the
baud rate must be set to 19.2k to match the
EMP baud rate, unless you use the autobaud
feature.
None disallows flow control.
CTS/RTS is hardware flow control.
XON/XOFF is software flow control.
CTS/RTS +CD is hardware plus carrier-detect flow
control.
Table 22: Boot Menu
Description
If Enabled, system verifies the diskette type on
boot.
Disabled results in a faster boot.
This option should remain enabled unless you
install more than eight hard drives in the
system.
Enters submenu.
Enters submenu.
Enters submenu.
Selects the maximum number of I
assigned a DOS drive letter.
All timeout values are multiplied by this number.
O drives
2
Setup Menus 95