Emp Console Requirements - Gateway ALR 9200 Maintaining And Troubleshooting

132 Maintaining and Troubleshooting the Gateway ALR 9200 Server
The three EMP access modes are disabled, pre-boot, and always active.
Table 29: EMP Console Access Modes (Server Configured for
Mode Server is
powered off
Disabled Redirect window
appears, but is blank
Pre-boot EMP commands
available
Always Active EMP commands
available
* You can modify the operation mode by selections in the POST reset and POST power-up dialogs.
These are server control dialogs available with the EMP Console.
Table 30: EMP Console Access Modes (Server not Configured for
Mode Server is
powered off
Disabled Redirect window
appears, but is blank
Pre-boot EMP commands
available
Always Active EMP commands
available

EMP Console Requirements

This section outlines the requirements and configurations necessary for
using the EMP console.
Operating System, Windows NT:
•
Windows NT 4.0 or later
•
24 MB of RAM, 32 MB recommended
•
20 MB disk space
Client Configuration: The EMP console supports all COM ports on the
client system, along with any Windows NT/95 compatible modem.
Console Redirect)
During POST
Redirect window
Redirect window
Redirect window
Console Redirect)
During POST
Redirect window
appears, but is blank
EMP commands
available
EMP commands
available
After Operating
System boots
Redirect window
Redirect window
EMP commands available
After Operating
System boots
Redirect window
appears, but is blank
Redirect window
appears, but is blank
EMP commands
available