Maintenance Menu Operations - Sony PDW-HR1 Operation Manual

Item
M55: DUPLEX
a)
M56: JUMBO FRAME
M57: DNS1
M58: DNS2
M59: UPnP
M5F: RESET NET CONFIG
a) A jumbo frame is a frame larger than the maximum 1514 bytes (not
including FCS) of the standard Ethernet frame. Jumbo frames make it
possible to deliver larger payloads per packet. Since fewer packets need to
be routed, packet processing overhead is lower and network throughput is
potentially improved. (Note that this item is enabled only when LINK
SPEED is set to "1000Mbps". For it to work, all other devices that handle
packets on the network must also support jumbo frames.)

Maintenance menu operations

This section describes the indications in the maintenance
menu and how to change the settings.
To display the maintenance menu
Holding down the HOME button, press the MENU button.
The maintenance menu appears on the video monitor
display and the currently-set menu item is displayed in
reverse video.
Meanings of indications on the menu
screen
On-screen indication Meaning
Right-pointing arrow Pressing the PUSH SET knob or
(c) at the right of a the b button switches to the next
menu item lower menu level or to a setting
selection screen.
M5: NETWORK: Items relating to network settings
Setting
Set the communications method.
AUTO, Full Duplex, Half Duplex
For how to set the communication method, see "To change network settings" (page 162).
Set the size of jumbo frames.
9014, 4088, OFF(1514)
Note
This value does not include the 4 bytes of the FCS (Frame Check Sequence).
Set the address of DNS server 1.
000.000.000.000
Notes
• The address of DNS server 1 cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired address of DNS server 1, close the maintenance menu
and then open it again.
Set the address of DNS server 2.
000.000.000.000
Notes
• The address of DNS server 2 cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired address of DNS server 2, close the maintenance menu
and then open it again.
Select whether to enable the UPnP (universal plug and play) function.
DISABLE: Disable the UPnP function.
ENABLE: Enable the UPnP function.
Reset network settings to the factory defaults.
SAVE function button (F5): Reset.
MENU button: Return to the next highest menu level without executing the reset.
On-screen indication Meaning
Left-pointing arrow (C) Pressing the PUSH SET knob or
at the left of a menu the B button switches to the
item previous (higher) menu level.
Character string at the Current setting of the menu item
right of a menu item When shown with a colon (:):
When shown with a raised dot
An * (asterisk) in a Factory default setting
complete list of settings
To change a menu item setting
Carry out the following operations to change the setting.
For information about how to change network settings see
next section "To change network settings".
the current setting is the same
as the factory default setting.
(.): the current setting is
different from the factory
default setting.
Maintenance Menu
161