Sony PDW-HR1 Operation Manual page 110

7
Select EDIT MODE in the Edit Menu to select the
editing mode (see page 108).
8
Use the PLAY, PAUSE, and STOP buttons and the
shuttle/jog dial to play the edit list, and set edit points
in the edit list (see step 5).
When there are no sub clips
This operation is not needed, because edit points
cannot be set.
If you skip setting edit points
The material is added at the playline position.
To enlarge or reduce the scale of the timeline
Press the + TRIM or – TRIM button.
To modify audio transitions at edit points
Select EDIT POINT in the Edit Menu, and then select
"cut"or "fade" (fade out and fade in).
Note
Depending on the combination of edit mode and edit
point settings, it may not be possible to execute the
edit. In this case, the DELETE button flashes. Delete
one of the edit points, and check that the DELETE
button is not lit.
9
Press the PREVIEW button.
The editing screen changes to a full-screen viewer,
which plays the edit section, including the preroll and
postroll sections.
To reset edit points, repeat steps 5 to 9.
Preview execution range
The following figure shows the preview execution
range for an example in which In and Out points were
set in material C0225, and then material C0225 was
inserted into sub clip C0002.
1 Preview execution range
1)
2 Preroll time
3 Postroll time
1) When PLAYER SEL in the Edit Menu is set to "disc(clip)",
"disc(voice)" or "SxS": 3 seconds
When PLAYER SEL in the Edit Menu is set to "external": The time
specified by P-ROLL TIME in the Edit Menu.
Note
When PLAYER SEL in the Edit Menu is set to
"external" and EDIT MODE is set to "insert", the
postroll section is not played.
110
Editing Operations
10
Press the AUTO EDIT button.
The clip range specified in step 5 is added to the edit
list in the edit mode specified in step 7, and the
updated edit list is saved automatically.
If you did not load an edit list in step 2, use the Save
Clip List as... command in the Edit Menu to save the
edit list (see page 88).
When two edit points or less have been set, the editing
screen changes into full-screen playback of a section
until the edit section is confirmed, including the preroll
and postroll sections.
Note
The preroll and postroll sections are not played when
PLAYER SEL in the Edit Menu is set to "external".
If you started an open-end edit
If you started an open-end edit (by setting the material
and edit list In points only), then view the playback on
the video monitor, watching for a frame to use as the
end of the material. When the frame appears, press the
ENTRY button while holding down the OUT button,
or press the STOP button.
11
To add more material, repeat steps 3 to 10.
To review editing results
To review the editing results after an auto edit, press the
PREVIEW button while holding the SHIFT button down.
The editing screen changes to a full-screen viewer, which
plays the edit section, including the preroll and postroll
sections.
Review execution range
The following figure shows the review execution range for
an example in which In and Out points were set in material
C0225, and then material C0225 was inserted into sub clip
C0002.
1 Review execution range
2 Preroll time: 3 seconds
3 Postroll time: 2 seconds
Recording range when PLAYER SEL is set
to "external"
The range from 2 seconds before the In point to 2 seconds
after the Out point is recorded to the disc.